Landing surface is wet, break action poor ( medium). 道面湿,刹车效能差(中等)。
The loss of power by using the wheel gears mainly lies in the loss of the surface of action, the loss of oil resistant when the gears stir the lubricating oil, and the loss of bearings. 齿轮传动的功率损失主要在于:啮合面的摩擦损失、轮齿搅动润滑油时的油阻损失和轮轴支承在轴承中和轴承内的摩擦损失。
The forces applied on the molten pool at the cathode surface under the action of an external magnetic field during vacuum arc coating are analyzed. 分析了在外加磁场作用下,真空电弧镀膜中阴极靶面液池的受力情况,导出了液滴喷溅特性受磁场影响的关系式。
Floating hammer, force of impact don't act on basic shaft and surface, have buffer action. 环锤浮动,冲击力不直接作用于主轴和壳体,有一定的缓冲作用。
Once gimbal got heated it bents itself toward platter's surface and this action reduces flying height. 一旦得到了热烈的万向节是本茨对盘片表面上的行动本身,这降低了飞行高度。
Therefore, it is put forward that surface action electrical heating technique is applied to prevent ice barrier in gas production and transportation pipelines. 为此,提出应用集肤效应电伴热技术防治采输气管线水合物冰堵。
In addition, the symmetry of the biaxiality induced by the surface action is considered in this simulation. 计算中同时考虑了基板作用引起的双轴对称性。
The surface effectively resists corrosive action of water, saltwater spray, alkalies, crude oil, and natural gas. 这种表面能有效地抵御水、盐雾、碱、原油和天然气的腐蚀反应。
A general expression for the calculation of contact line and surface of action can be easily derived from the geometric model developed from this geometry transformation. 以上述几何变换所提供的几何模型为基础,可以简单地导出一个计算接触线和啮合面的一般公式,这个公式既适用于可展曲面,也适用于(?)可展曲面。
A graphic analysis and calculation of contact line and surface of action in conjugate motion 共轭曲面中接触线和啮合面的图解分析与计算
Due to the stress concentration for the presence of the hole or the other surface flaw ( for example, semi-sphere cavity or cylinder cavity) in the component, cracks are likely to initiate at the hole or the surface flaw under the action of fatigue loading. 由于构件中孔洞或其他表面缺陷(比如半球形、圆柱形等)的存在所产生的应力集中,在疲劳载荷的作用下裂纹便可能在孔洞或表面缺陷附近出现。
During the ocean-atmosphere coupling, the change of surface wind perform the key action. 在海气耦合的过程中,海表风场的改变起了主导作用。
This model establishes a specific correlation between surface tension and mass action concentration ( activities) in the inner and surficial of slag and alloy founded upon inner and surficial structure of slag melt and alloy melt, then calculates the interfacial tension of them. 此模型在炉渣熔体与合金熔体的内部和表面结构的基础上,建立起了熔渣与合金内部和表面的质量作用浓度(活度)与其表面张力间的关系,进一步计算二者间的界面张力。
Adsorption behavior on steel surface and corrosion inhibiting action of polyoxyethylene benzyl ammonium chloride 聚氧乙烯苄基氯化铵在钢铁表面的吸附及缓蚀性能研究
The developing process of the breakwater surface scouring with the action of irregular wave and regular wave, and the dynamical equilibrium section under the design condition are discussed in detail. 文中详细阐述了宽肩台式防波堤在不规则波及规则波作用下冲刷剖面的演变过程及其在设计条件下最终形成的动力平衡断面。
In the paper, the hydrological underlying surface is defined, the elements composing the hydrological underlying surface and their action on water yield and concentration are analyzed. 提出了水文下垫面的定义,分析了组成水文下垫面各要素的基本性质及其在产、汇流方面的作用。
The surface cleaning action, caused by the cathode sputtering phenomenon in ion bombardment brazing in glow discharge is investigated in this paper. 本文研究了辉光放电离子轰击钎焊时阴极溅射现象对工件表面的净化作用。
This paper first establishes a geochemical model based on surface complexion and then coupled it with traditional advection dispersion model to constitute a solute migration model, which can deal with surface complexion action. 本文建立了一个基于表面络合吸附作用的地球化学模式,并将其与传统的对流-弥散模型相耦合,建立了一个能够考虑表面络合吸附影响的溶质迁移模型。
According to the relevant computational method for the objects setting on surface under the earthquake action, the displaying characteristics of the cultural relics and the seismic design parameters of the museum, a simple and practical computational model, which is on the safe side, is introduced. 根据相关浮放物在地震作用下的计算方法、上海博物馆文物的陈列特征及防震设计参数,给出了简便实用、偏于安全的计算模型。
The refilling of carbon nanotubes was discussed through measuring the surface tension and capillary action of mixed metallic salts, the dense degree of FeNi alloy nanoparticles inside carbon nanotubes increased and the yield of filling increased. 本论文的主要工作:1、测定混合金属盐的表面张力及毛细作用,探索二次填充碳纳米管,提高FeNi合金纳米粒子在碳管内的密集程度,填充效率增加。
Since the diameter of nanoparticle is quite small, and nanoparticle has specific properties such as the surface action, volume action, quanta-size action and tunnel action, the saturated pressure of refrigerant/ mineral oil mixture is affected by adding nanoparticles. 纳米颗粒由于其粒径很小,具有体积效应、表面效应、量子尺寸效应和宏观量子隧道效应等特性,所以添加纳米颗粒后会影响到制冷剂/矿物油混合物的饱和蒸气压等热力性质。
The paper states its action mechanism mainly expresses in bridge action, surface activated action and bonding action. 论述了JS水下混凝土抗分散剂的作用机理主要表现在桥架作用,表面活性作用和桥键作用3个方面。
TL-2000 consolidating dose for road surface has important action on prevention of water damage. TL-2000路面强化剂对防止水损害的发生具有重要的作用。
Photocatalytic reaction could be simply decomposed as three continuous processes as follows: photon transfer step, surface action step, and diffusion step. 因此将光催化反应简单分解为3个速率步骤,即光子传递步骤、表面作用步骤、扩散步骤。
Dynamical Solidification Characteristic of Metal Surface Alloying by Action of Continuous Laser 连续激光作用下金属表面合金化的动态凝固特征
It is quantitatively evaluated that the preservation conditions of Carboniferous gas reservoirs in East Sichuan are closely relative to surface erosion action but irrelative to the structural faults. 进而定量地评价出川东石炭系气藏的保存条件与地表侵蚀作用密切相关,而与构造断层无关。
Surface Optimizing Action of Nanophase Lubrication Material 纳米润滑材料的表面优化行为
Rainfall runoff is a kind of runoff that is Tableed by rainfall, which joins the river net and merges at the section of the basin through the surface or underground action. 降雨径流是由降雨形成的径流,沿地表或地下运动汇入河网并向流域出口断面汇集。
In the partial slip regime ( PSR), the fatigue cracks very easily initiated and mainly propagated parallel to the surface under the action of DRF. And the local fatigue was main damage formal in this regime. 在部分滑移区,复合微动作用下极易导致疲劳裂纹的萌生并主要沿平行于接触表面方向扩展,该区域微动损伤主要表现为局部疲劳。
We can draw a conclusion that for simply supported girder bridge with constant stiffness, seven inclinometers are enough to measure the deformation surface under the action of deadweight, and it is able to reach very high accuracy. 应用得出对于等刚度简支梁,仅需7个倾角仪就可测其在自重作用下的变形曲面,且达到了很高的精度。